Stud Sensor - Edge Detection - 3/4" - Red/Black

Article#00276741 Model#CMHT77633 Format3/4"
Stud Sensor - Edge Detection - 3/4" - Red/Black
 

Description

This Craftsman(R) stud sensor is designed to help you find wooden or metal studs through your drywall. It works for a depth up to 3/4" and can even locate stud edges for both wodden and metal studs. Working on surfaces covered by wallpaper and fabric, this device is shock and water-resistant for an unmatched durability. This stud sensor is covered by a lifetime limited warranty.

Technical specifications

Depth :Up to 3/4" Warranty :Lifetime limited warranty Packaging :Each Color :Red and black Type :Stud sensor Accuracy :Detects wooden and metal studs as well as their edges

You may also like

FULLER
Locking Measuring Tape - Plastic/Rubber - SAE/Metric - 25'
Format 1"x25'
Article #70155073
Model #750-0030
★★★★★ ★★★★★
0
(0)
FULLER
Fuller 3-Piece Level Set with Measuring Tape
Format 3PC
Article #01215278
Model #40-5711
★★★★★ ★★★★★
1
(1)
BOSCH
GLL30 Self-Leveling Cross-Line Laser Measure - 30'
Format 30'
Article #19836143
Model #GLL 30
★★★★★ ★★★★★
4
(57)
BOSCH
Self-Levelling Cross-Line Laser with Mounting Device - 40'
Format 40'
Article #19836291
Model #GLL40-20G
★★★★★ ★★★★★
4.2
(14)
BOSCH
Laser Measuring Tool - 100 ft
Format 100'
Article #19835799
Model #GLM 30
★★★★★ ★★★★★
4.4
(44)
BOSCH
Distance Measuring Laser - BLAZER GLM20 - 65' Range
Format 0-65'
Article #19835938
Model #GLM20
★★★★★ ★★★★★
4.8
(5)
BOSCH
GLM42 Compact Laser Measure - 135'
Format 135'
Article #19836179
Model #GLM 42
★★★★★ ★★★★★
4.5
(39)
BOSCH
Bosch Digital Multi Scanner - 9 V - Blue and Black
Format 9V
Article #19835505
Model #GMS120
★★★★★ ★★★★★
2.5
(2)
BOSCH
Laser Distance Measurer - 165'
Format 165'
Article #19835926
Model #GLM50C
★★★★★ ★★★★★
0
(0)
BOSCH
Combination Point and Line Laser Level
Article #19835765
Model #GLL 1P
★★★★★ ★★★★★
4
(1)
BOSCH
Laser Measuring Tool - 35' Scope
Format 35'
Article #19835970
Model #GLM10X
★★★★★ ★★★★★
5
(2)
BOSCH
Bosch GTL2 Laser Level and Square
Article #19835434
Model #GTL2
★★★★★ ★★★★★
3
(2)
BOSCH
GLL100 GX Self-Leveling Cross-Line Laser - 100'
Format 100'
Article #19836180
Model #GLL 100 GX
★★★★★ ★★★★★
4.3
(14)
BOSCH
Self-Leveling Cross-line Laser Level - 40' range
Format 40'
Article #19836269
Model #GCL2-55
★★★★★ ★★★★★
4.3
(22)
BOSCH
GLL3-15 Self-Leveling Three-Line Laser Measure - 50'
Format 50'
Article #19836072
Model #GLL 3-15
★★★★★ ★★★★★
4.1
(20)
BOSCH
Red Laser Level - 200' - Three 360° Planes
Format 200'x360DG
Article #19836277
Model #GLL3-300
★★★★★ ★★★★★
5
(4)
BOSCH
5-Point Self-Leveling Alignment Laser - 100'
Article #19835427
Model #GPL 5 R
★★★★★ ★★★★★
4.1
(10)
FULLER
Ogee Cut Adapter
Article #01215203
Model #320-1755
★★★★★ ★★★★★
0
(0)
BOSCH
2-Point Self-Leveling Laser Level - 30'
Format 30'
Article #19835423
Model #GPL2
★★★★★ ★★★★★
4.7
(3)
BOSCH
GLM10 Laser Measure - 35'
Format 35'
Article #19836187
Model #GLM 10
★★★★★ ★★★★★
5
(2)
BOSCH
Green Laser Level - 200'/360° - 12 V - Bluetooth
Format 12Vx200'x360DG
Article #19836278
Model #GLL3-330CG
★★★★★ ★★★★★
3
(2)
BOSCH
Tile and Square Layout Laser - 65'
Article #19835443
Model #GTL3
★★★★★ ★★★★★
5
(1)
BOSCH
GLL2-20 Self-Leveling 360° Cross-Line Laser Measure - 65'
Format 360DG
Article #19836074
Model #GLL 2-20
★★★★★ ★★★★★
4.6
(21)
BOSCH
Bosch Digital Level - 24"
Article #330622794
Model #GIM 60
★★★★★ ★★★★★
0
(0)
BOSCH
Bosch Digital Multi Scanner
Article #330609658
Model #GMS 120
★★★★★ ★★★★★
2.5
(2)
  • bvseo_sdk, java_sdk, bvseo-4.0.0
  • LOCAL, getContent, 0ms
  • QUESTIONS, PRODUCT
  • bvseo-msg: The resource to the URL or file is currently unavailable.;
Stud Sensor - Edge Detection - 3/4" - Red/Black is rated 3.4 out of 5 by 110.
Rated 4 out of 5 by from Craftsman Stud Finder This one is basic, and having used it to check for studs, is quite accurate. The tone is loud, and that's a good thing when there is construction work going on around me. I like the red color, because it stands out in my tool bag for an easy grab and it is super light weight. If you're looking for a low priced stud finder (metal and wood), this one will work just fine. The only reason it got 4 stars is because it does not alert to possible electrical wires. There are some jobs that require that feature to ensure my safety. It uses a 9 volt battery. [This review was collected as part of a promotion.]
Date published: 2018-09-18
Rated 3 out of 5 by from It works, sort of..... I was installing flush mount fluorescent lights in my garage and I needed to locate the joists, and the reviews for this item were decent, so I picked one up. Like most low cost stud finders, you have to fiddle with it a bit to get a good reading, or to get it to read at all. For whatever reason, this thing found the edges of wall studs no problem, but no matter what I did, I could not get it to locate ceiling joists. I ended up using a magnetic stud finder. I wasn't going to spend a lot on an item I'll rarely use, but I probably should've spent a little more on something else. I'll keep it. [This review was collected as part of a promotion.]
Date published: 2019-01-23
Rated 1 out of 5 by from Waste of Time Purchased this based on the overall good ratings and I could not be more unimpressed. I used fresh batteries and followed the instructions. To my amazement, if I went over an area searching for a stud, the device would beep in different areas of 1-3 inches different from previous measurements. I have used a more expensive stud finder before so I know how to read edges but this device was just wrong every time. Save your money and buy a better quality one. [This review was collected as part of a promotion.]
Date published: 2019-01-28
Rated 4 out of 5 by from good tool for the price Unit works as described. It does a good job locating the edge of a stud or header. It cannot tell the difference between a 2X4 stud and an electrical cable . The unit needs a 9 volt battery that is NOT included. [This review was collected as part of a promotion.]
Date published: 2018-09-19
Rated 1 out of 5 by from A Very Evil Stud Finder Perhaps we received a faulty one, but this thing was VERY inconsistent at finding studs and frustrating to work with. We recently had our room drywalled and know that there are studs approximately every 16 inches. This thing found maybe 5 out of 30 studs, all while making the irritating beep sound and dragging gray lines on our white walls with it's soft black feet. We went old school and resorted to knocking to find all of the studs in the room. Useless! [This review was collected as part of a promotion.]
Date published: 2019-01-29
Rated 3 out of 5 by from Works but annoying power design Pros: - About $10 cheaper than other stud finders. - Does find studs - Has a notch at top useful for marking the edge of the stud with pencil. Cons - Requires you to hold in the power button the entire time. If you accidentally slip your finger off, it resets and will beep when turned back on and calibrating. In other words, you could get some false positives if your not careful to keep the button pushed in. Best to find a couple of adjacent studs which will likely be 16" apart on center. - No function to find hot wires. - Most other stud finders can go 1.5" deep, though 0.75" isn't a problem with most drywall. - It's got pads on the back face but VERY thin. It still makes a sound like it's scraping the wall. Conclusion: It works. But since you will likely only require 1 stud finder in your life, for $10 more, why not get one that will work better and doesn't require you to hold the button in the entire time? [This review was collected as part of a promotion.]
Date published: 2018-10-03
Rated 4 out of 5 by from got the job done sometimes it needed to be calibrated a few times before getting it to work but it was always right about where the stud was and calibration is a breeze. good for the money. saved me alot of holes in my wall [This review was collected as part of a promotion.]
Date published: 2018-09-30
Rated 1 out of 5 by from Waste of Money I bought this basic stud finder for a simple task but the stud finder would not calibrate. The red and green light stayed on together with the constant beep even after trying multiple walls. I think I wasted a battery just trying to calibrate it. Taking it back for a refund [This review was collected as part of a promotion.]
Date published: 2019-08-14
  • y_2020, m_12, d_1, h_16
  • bvseo_bulk, prod_bvrr, vn_bulk_3.0.12
  • cp_1, bvpage1
  • co_hasreviews, tv_0, tr_110
  • loc_en_CA, sid_00276741, prod, sort_[SortEntry(order=RELEVANCE, direction=DESCENDING)]
  • clientName_renodepot
  • bvseo_sdk, java_sdk, bvseo-4.0.0
  • LOCAL, getContent, 0ms
  • REVIEWS, PRODUCT

Changing store

You are about to change your selected store.

Please note that if you change stores, prices and availability shown on the website may vary and your shopping cart will empty.

Keep my store Change store